[PCB_FORUM] Re: Dynamic Fill not updating

Try turning on the boundary subclass under stackup for the layers in
question.  Delete the boundaries and try regenerating the shape again.  I
had a similar problem a few months ago and this resolved it.

 

Diana Jackson

PCB Designer

Meristem Designs

613-256-4246

 

   _____  

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Ed Caldwell
Sent: Wednesday, November 30, 2005 9:38 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Dynamic Fill not updating

 


I have a design to spin from another company and two of the dynamic fills
are not updating. 

I get a command line message... 

Updating dynamic shape (3 of 2) Gnd, Boundary/Top @ (3650.00 -9120.00)... 
Updating dynamic shape (2 of 2) Gnd_Earth, Boundary/Top @ (107.00
-9388.00)... 

Yet the shapes are not being updated. 

State: Out of date  Extents: (57.00 -9388.00) (10616.00 -70.00)  Net:
GND_EARTH 
State: Out of date  Extents: (360.00 -9230.00) (3940.00 -8360.00)  Net: GND 

The shapes are not fixed... Anyone know any possibilities why the no update?


Thanks,
Ed 

Ed Caldwell 
CIrcuit Board Designer 
Electronic Design Services 
Canton, GA 30115 

--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.362 / Virus Database: 267.13.10/189 - Release Date: 11/30/2005


-- 
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.362 / Virus Database: 267.13.10/189 - Release Date: 11/30/2005

Other related posts: