Try holding the shift key as you close the window. Matt Messinger From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Carrow, Dennis Sent: Wednesday, July 21, 2010 9:55 AM To: 'icu-pcb-forum@xxxxxxxxxxxxx' Subject: [PCB_FORUM] Re: Dual Monitor Setup Open allegro, move the screen shot to the monitor you wish it to open on, enlarge screen shot to full size, and exit the program by hitting the X in the upper right of the screen. Next time you open the program it will be on that monitor. ________________________________ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Reade, Sue Sent: Wednesday, July 21, 2010 8:48 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Dual Monitor Setup It seems to always open up where I closed it last. I'm not sure that there is anything for a specific application that would direct it to a specific monitor. Sue Reade CAD Engineer, Hardware Engineering, NSG (o) +1.919.461-1047 | (m) +1.919.819-8092 From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dave Seymour Sent: Wednesday, July 21, 2010 9:44 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Dual Monitor Setup Hey Everybody, I got a dual monitor set up for Allegro. I would like Allegro to always open on the right monitor, the left being my main monitor. What controls which monitor Allegro opens on? Thanks Dave Dave Seymour Ixia www.ixiacom.com 919.267.4840 ________________________________ {CONFIDENTIALITY NOTICE} This electronic mail message is transmitted exclusively for the intended recipient. It is not intended for transmission to, or receipt or use by, any unintended or unauthorized persons. Any review, use, printing, copying, retention, disclosure or distribution not expressly authorized is strictly prohibited and may violate applicable laws. If you have received this message in error, please (i) do not read it or any attachment, ii) immediately reply to the sender that you received the message in error, and (iii) erase or destroy the message and any copies that may exist. Thank you.