[PCB_FORUM] Re: Drill Legend probs

Dave,

 

It's the Drill Table (Drill Legend, Table whatever) that I'm trying to
generate.

I can run NC Drill, and there is only one place this drill size (2.4 mm)
is used.

The padstack is defined with "Square" as the "Figure", and "A" as a
"Character".

 

None of this makes sense.  I think it's time for official support.

 

Thanks,

Gary

 

 

 

Gary E. MacIndoe

PCB Design Engineer

Longmont, Colorado

 

amd.com

gary.macindoe@xxxxxxx

 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dave Seymour
Sent: Monday, April 09, 2007 2:38 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Drill Legend probs

 

Look at the drill table.

Somewhere, there are the same hole size with
different drill figures.

Example:

.012 = A
.012 = B


Different pad padstacks with the same hole and same figure
are fine. This is same hole with different figures.

Dave


Macindoe, Gary wrote:



Hey guys,

 

I'm trying to help a fellow designer in our company (remotely). I have a
copy of his database, it's setup as Metric.

 

15.5.1, XP Pro.

 

When running Manufacture -> NC -> Drill Legend, it fails with the
following message:

 

>>> Begin processing drill holes.

>>> Warning : Hole 2.4000-0.0000-C-N-0.0000-0.0000 uses multiple drill
figures.

>>> End processing drill holes.

 

To me it looked like "2.4000-0.0000" were coordinates, but there is no
hole there.

I've not seen this one, but I have had two different padstacks with the
same drill figure, which runs fine.

 

Any ideas as to how to find the offending hole?

 

Thanks,

 

Gary

 

 

 

 

Gary E. MacIndoe

PCB Design Engineer

Longmont, Colorado

 

amd.com

gary.macindoe@xxxxxxx

 

 

 

 





-- 
Dave Seymour, CID+
Catapult Communications Inc.
800 Perimeter Park Dr, Suite A
Morrisville, NC 27560
 
Direct: (919)653-4249
Main: (919)653-4180
Fax: (919)653-4297
 
Dave.seymour@xxxxxxxxxxxx

GIF image

Other related posts: