[PCB_FORUM] Re: Display pin numbers?

Mark,

Well, you still don't say if you (or someone) has modified
the symbols in the design. Generally speaking, I never
modify symbols within the design. If not then extract them
and their padstacks, load them into allegro and create a new
symbol. Then refresh the symbols. I don't know if this will
work as I have never tried it. But, it's seems worth a
try. If any of the symbols have been modified in the design
you will find out pretty fast. In those cases, either
modify the symbol to match or don't refresh it. It might
also be possible to just refresh the padstacks in the same
manner. Again, I don't know if it will work and cannot
test it as I don't have any pre-14.2 designs to work with.
It is possible that you will need to bring the padstacks in
to the allegro padeditor and write them out again to get it
to work in any case. This is kind of a padstack issue,
after all.

Good luck,
Kevin

Mark Salberg wrote:
Hello Kevin,
From what I can tell...the *Package Geometry/Pin numbers* was added in 14.2. But if a board was designed prior to that (even though upreved to a newer version). Allegro uses the database library so that any mods to a component pin, etc...(design specific) would not automatically refresh to remove any mods. Now with a 13.5 file upreved to 15.1 through DB Doctor, pin numbers will not display unless I refresh all. But this would remove any mods made in the past. (Dangerous).

How can I use Allegro to uprev the design library without changing any mods, yet allow pin numbers to display?
As I mentioned, the "board" has been upreved by Allegro 15.1.
I know if I "refresh", Allegro will update any mods back to the default library version.

As Jean mentioned, if I extract...the symbols will overwrite any mods that were made.

We have tech's using the free viewer that would like to see pin numbers displayed on components, but will only work on boards that were designed in 14.2 or later without refreshing.

Thanks for the feedback!
Mark
-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list please login at
http://www.freelists.org. Our list name is icu-pcb-forum
or go to http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
        Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum.

SUBSCRIBE:  icu-jobs-forum-subscribe@xxxxxxxxxx
POST:       icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------

Other related posts: