[PCB_FORUM] Diff pair Constraints and CM
- From: Dave Seymour <deseymour-pcb@xxxxxxxxxxxxx>
- To: icu-pcb-forum@xxxxxxxxxxxxx
- Date: Thu, 10 Mar 2005 16:05:29 -0500 (GMT-05:00)
Fresh 15.2 design.
I assign a diff pair to two nets.
Set the diff pair spacing in the NET_PHYSICAL_TYPE = DIFF
with to 11mils. Neck witdh, gap all set.
Assign the DIFF property to the nets.
Assignment table correct.
Nets route at 11mil space. Tracks obey all parameters.
Great.
How come the the 11 mil gap (etc) does not show in the CM
on the DIFF page?
Thanks
Dave
--
Dave Seymour, CID+
Catapult Communications Inc.
800 Perimeter Park Dr, Suite A
Morrisville, NC 27560
Direct: (919)653-4249
Main: (919)653-4180
Fax: (919)653-4297
Dave.seymour@xxxxxxxxxxxx
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list please login at
//www.freelists.org. Our list name is icu-pcb-forum
or go to //www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
Want to post a job listing ? DON'T DO IT HERE!
Better yet, join our jobs listing forum.
SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx
POST: icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------
Other related posts:
