[PCB_FORUM] DPTol problem

        Hopefully someone can help me solve this. Using constraint
manager on some diff pairs and trying
        to utilize delay tune and the DPTol slide gui to come within
tolerance. Upon grabbing the leg of the
        pair in question I am getting red and minus measurements. Upon
getting close to where it should be
        going green, it jumps to the plus measurement and red again. It
never shows green. One of our SI engineers
        on a different machine with the same board and same net can get
it to go green, he cannot get it to
        go green on my machine. Is there any setting locally or in the
env file that could be causing this? A bug?
        I am using a newer release of software (same base 15.5.1) than
he. Any ideas would be a great help.

        thanks,

        Mike Gnieski
        EMC2 Corp.
        Hopkinton, Ma

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: