[PCB_FORUM] Re: Cross probing between DxDesniger and Allegro?

DownStreamTech has a tool that does this. It's a functional tool, but I
find it a bit sticky sometimes, in that both tools have to be available,
it locks up sometimes, and it's protocol is a bit awkward. I've used it
in a test only environment and yes it does work. 

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
Sent: Thursday, June 08, 2006 2:50 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Cross probing between DxDesniger and Allegro?

Hi,

I heard a while ago that there was a company that offered a utility that
allowed crossprobing between DxDesigner and Allegro PCB.  Does anyone
recall who makes that?

Regards,

Austin
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: