Thank you all for quick response.  I check it out as soon as I get to work :)

---

From: "Scott, Ron" <rg-scott@xxxxxx>
Reply-To: icu-pcb-forum@xxxxxxxxxxxxx
To: <icu-pcb-forum@xxxxxxxxxxxxx>
Subject: [PCB_FORUM] Re: Correcting the drill chart output
Date: Tue, 12 Dec 2006 07:40:38 -0600

Jim,

 

The permanent answer to your dilemma is to open up the actual drill file(.dlt) in a text editor and you'll find in the nclegend file an assortment of built in default tables. There are tables for cm, in,mil, etc. Open up the desired .dlt and you can edit the size and spacing to your heart's content. Hope this helps. 

 

Cheers,

Ron Scott C.I.D.+
Texas Instruments
Storage Products Group
Tel:   214.567.4715
Cell:  972.816.7978
rg-scott@xxxxxx

 

---

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Jim Goshorn
Sent: Tuesday, December 12, 2006 07:33
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Correcting the drill chart output

        Seiji, Go to >Setup>Text sizes > Text block 9. Make the adjustments to that line and it should be OK.
        
        Jim

At 12:27 AM 12/12/2006 -0800, you wrote:

Hi everyone,

I am sorry to keep bothering everyone.  I have this irritating issue that I can't seem to solve.  It seems that everytime I use NC Drill Legend the chart seems to be smushed together and I have to adjust it everytime.  I have looked to see how I can fix this problem, but I can't seem to find it.  Can anyone help me with this?  Thank you in advance.

Seiji
----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------

Jim Goshorn
MCL, Inc
501 S Woodcreek Rd
Bolingbrook, IL 60440
630-771-7205