[PCB_FORUM] Re: Constraint areas not following rules

Or run DBDoctor

 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of richard moffat
Sent: Tuesday, January 31, 2006 5:55 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Constraint areas not following rules

 

Hi all

 

Allegro 15.5.1,  Designer + Expert

 

Has anyone had problems with constraint areas not following spacing
rules?  It seems to ignore the area when first drawn.  It seems you have
to move the area, ie pick it up and replace it again, for it to DRC
properly.

 

Cheers,

Richard


NOTICE: This message contains privileged and confidential
information intended only for the use of the addressee
named above. If you are not the intended recipient of
this message you are hereby notified that you must not
disseminate, copy or take any action in reliance on it.
If you have received this message in error please
notify Allied Telesyn Research Ltd immediately.
Any views expressed in this message are those of the
individual sender, except where the sender has the
authority to issue and specifically states them to
be the views of Allied Telesyn Research.

Other related posts: