[PCB_FORUM] Re: Compare Design

is this primarily a schematic design differences tool (netlists)?  I have not 
used this, but just checked and I have a license for it.  I looked at the 
tutorial and it started talking about Concept.  We are Capture CIS driven.  
 
Does this tool cover PWB comparisons?  
 
I have typically done that by loading and comparing gerbers using Viewmate.  I 
set different layers to contrasting colors and then load each gerber I want to 
compare.  Where the gerber is the same, the colors merge, where it is 
different, the contrasts show.  
 
This obviously is a very visually driven slow process.  
 
TIA

-----Original Message-----
From: Schwartz, Jerome [mailto:jschwa01@xxxxxxxxxx]
Sent: Thursday, September 23, 2004 10:09 AM
To: 'icu-pcb-forum@xxxxxxxxxxxxx'
Subject: [PCB_FORUM] Re: Compare Design 


Van,
 
    In your project manager see TOOLS / DESIGN SYNC / DESIGN DIFFERENCES.
 


 Regards,

      Jerry Schwartz, CID+

      IPC Certified Designer

     "May The Schwartz Be With You."

 

Designer 3 
Harris Corporation GCSD              Voice (321)-727-5474 
P.O. Box 37, MS 1/9843               Fax   (321)-727-6007 
Melbourne, FL 32902-0037             Pager (321)-690-9797 
mailto:Jerome.Schwartz@xxxxxxxxxx                    
http://www.harris.com <http://www.harris.com/> 

 



-----Original Message-----
From: Van Huynh (huynh) [mailto:huynh@xxxxxxxxx] 
Sent: Thursday, September 23, 2004 1:01 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Compare Design 


Does anyone have a SKILL Compare_Designs, that works for version 14 or 15?
The one from Cadence Skill dir. doesn't run.
Thanks
Van Huynh
 
 <mailto:huynh@xxxxxxxxx>

Other related posts: