[PCB_FORUM] Re: CONCEPT->CM->dcf->allegro?

Hi Daniel,

> Using CM in Concept was tried but it was not able to understand xnets in
Concept. You had to
> setup the xnets in Allegro and then back annotate the Concept.

Just for clarification, Concept understands XNets when back annotated, but
you can't "instantiate" them in Concept beforehand?

Regards,

Austin
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: