[PCB_FORUM] Re: CDC2FAB and allegro 15.5

Dharma - sorry I did not read the whole email - ignore this comment

 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gerry Meier
Sent: Wednesday, June 20, 2007 12:49 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: CDC2FAB and allegro 15.5

 

Export the  design back to 15.5

 

 

 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dharma
Kemp-Bresett
Sent: Wednesday, June 20, 2007 12:45 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] CDC2FAB and allegro 15.5

 

Hello Again,

We seem to be beset by stumpers lately. :-)

We have been using 15.5 for some time now but apparently no-one has used
any of the version specific features until recently. Therefore, I have
always been able to open the board in 15.2 and do other things with it
like run CDC2FAB for the .cad file output for a particular customer. I
received a board from 15.5 that I cannot open in 15.2 nor can I run my
CDC2FAB on it. Being able to offer this output format is critical with
this particular customer however so far I cannot find a solution that
would not require us to purchase software that would be overkill for our
needs ( we do not need the entire fabmaster, unicam, gencad, harmony
etc. program just the ability to output the . cad file!). For this
particular board we were able to downrev to 15.2 (and run CDC2fab on
that) and do not appear to have lost anything integral but that may not
be the case in the future. (In addition to the fact that there is not
much point in having to downrev all our boards so that we might as well
not even have 15.5) I have been through the pcb forum archives,
sourcelink, and cdnusers, etc. and have found nothing so far that helps
me. Has anyone else encountered this problem?

Thanks in advance,

Dharma

 

KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents
contain information that is confidential, privileged or exempt from
disclosure under applicable law and is intended for the exclusive use of
the addressee. This information is private and protected by law. If you
are not the intended recipient, or have received this email in error,
you are hereby notified that any disclosure, copying, distribution or
use of the contents of this document in any manner is strictly
prohibited.

 


This correspondence and any attachments are considered confidential. If
you are not the intended recipient, please notify Freedom CAD Services,
Inc. immediately by either replying to this message or by sending an
email to operations@xxxxxxxxxxxxxx; please destroy all copies of this
message and any attachments. Thank you.

JPEG image

Other related posts: