[PCB_FORUM] Re: Artwork - rotated pads

try 274X

At 3/31/09 08:29 PM-0400, you wrote:

>Tool: Version 16.2, Allegro Expert. I can't find the solution on Sourcelink, 
>so am hoping this group can help. We have an old layout with a couple of 
>surface mount connectors rotated at 160 degrees. The pads are not 
>photoplotting correctly, although they must have at one time since we built 
>boards a few years ago. The viewlog says: 
>
>WARNING: The following pads were simulated with line draws
>  because the appropriate geometry was not in the aperture table:
> (GEOMETRY)      (WDT)   (HGT)   (ROTATION)
> Pad RECTANGLE   30.00   175.00      70.000  at (2545.35,1328.31)
>
>The pads are being drawn in at 90 degrees. Settings I'm using are: Gerber 
>4x00, Format 2.5,  and "Draw missing pad apertures" is checked. I've recreated 
>the aperture list using with and without rotation. What am I missing? Thanks 
>for any help you can provide.
>
>Alexis Meehan, Opnext, Inc.
>
>
>
> 
>----------------------------------------------------------- To 
>subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx 
>with a subject of subscribe or unsubscribe To view the archives of this list 
>go to http://www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: 
>Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx 
>----------------------------------------------------------- 
>-- This message has been scanned for viruses and dangerous content. 

-- This message has been scanned for viruses and dangerous content.

Other related posts: