I just exported a dxf file containing component outlines, pads and refdes for a large board and everything exported just fine. I'm running Allegro 15.2 s023(v15-2-51AB)[9/21/2004] Don Gillispie - CAE/CAD Support Tektronix Inc. PO Box 500 (M/S 39-645) Beaverton, OR 97077-0001 Phone: (503) 627-3038 Fax: (503) 627-2788 E-mail: don.gillispie@xxxxxxx -----Original Message----- From: Gene Carman [mailto:gcarman@xxxxxxxxxxxxxxx <mailto:gcarman@xxxxxxxxxxxxxxx> ] Sent: Wednesday, October 27, 2004 10:02 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Anyone have problems with DXFout on 15.2? I checked my path names... no spaces. GRIN I cannot seem to DXF out. I just changed to Version 15.2, so this is a new issue, and I do have the 10-5-04 ISR installed. The command line says: "E- DxfFile had errors - use Viewlog to review the log file." Only there are no errors in the viewlog... it seems quite happy, except for one thing... it is using the wrong Layer conversion file, and trying to write to the wrong DXF file name. That latter part really seems like an Allegro issue... Any suggestions folks? Gene Carman gcarman@xxxxxxxxxxxxxxx ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list please login at http://www.freelists.org <http://www.freelists.org> . Our list name is icu-pcb-forum or go to http://www.freelists.org/archives/icu-pcb-forum/ <http://www.freelists.org/archives/icu-pcb-forum/> Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum. SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx -----------------------------------------------------------