[PCB_FORUM] Allegro to Valor issue

This is for you Valor users out there.
When I load my gerber,drill and ipc netlist into Valor and run
Netlist Analysis,  it interprets all non-standard pads and pads with offsets
incorrectly. It uses the pad location and extents of the pad in it's calculation. 
Looking at the netlist, I can see why, because that is where the pads
are defined.
My solution is to globally replace the offending pads in the netlist with a small 
square.
Is it possible the part could be made differently such that the ipc netlist understands the correct pad size and location? 
Has anyone experienced this problem?

Thanks
Ron



-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx 
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: