[PCB_FORUM] Re: Allegro V15.7 (HIGHER TIER TOOL MESSAGE)

Hi
 
I've seen a similar problem when someone open the Constraint Manager
from inside
the schematic. Once they open it the schematic becomes the driver for
the CM not
Allegro.
 
There is a procedure to break this connection. If this is what's going
on you can contact
Cadence and they will tell you how to do it.
 
Dave
 
David Kelly
davidkel@xxxxxxxxx
720-562-6316
 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Mark Salberg
Sent: Tuesday, December 11, 2007 5:04 AM
To: Cadence User Group
Subject: [PCB_FORUM] Allegro V15.7 (HIGHER TIER TOOL MESSAGE)


Hi all,
Can anybody tell me why I am getting this message when opening a board
that was just packaged into from a board previously saved by the same
tool?
Saved board, package (Concept) schematic change into the saved board,
then output board = new name. 
I have lost all of my Constraint Manager groups for my matched
impedances. (OUCH)!
 

I always use Allegro Design Entry HDL L
 

Here are my import logic to Allegro settings:
 

With Allegro open I can see the option L (see below) NOT A HIGHER TIER
TOOL...THE SAME TOOL.

 

This is happening every time I package now.

Regards,
Mark

JPEG image

JPEG image

JPEG image

JPEG image

Other related posts: