[PCB_FORUM] Re: Adding a via to a .dra file...

Add the via type in constraints/physical. Even add multiple types.

Thurlow

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin
Sent: Tuesday, May 19, 2009 4:17 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Adding a via to a .dra file...

Hi,

OK, I give up.  How on earth do I add a via (to an epad) in a .dra file?
I
can add it as a pin (mechanical or connect) under "layout/pins", but
that
doesn't do what I want.  I want it to come out as type "via", not type
"pin".

I've done this before, but for the life of me, I just can't figure out
how...

Thanks,

Austin
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: