[PCB_FORUM] Adding Teardrops increases Etch Length

Hi All,

After done with length matching, i have added teardrops(fillet) to those & 
found increase in etch length & violates the existing length matching. Will the 
teardrops etch will be added to the trace length? Anyways to avoid this 
increase in length without deleting fillets?

Regards
Kumaran M
-----------------------------------------------------------------------------------------------------------------------------------------
GDA Technologies Ltd 
32 & 46 North Phase
Thiru Vi Ka Industrial Estate,
Chennai - 600 097.
Desk   :  +91-44-3061 3453
Mobile :  +91 98404 85650
 
-----------------------------------------------------------------------------------------------------------------------------------------
-- 
This message contains information from GDA Technologies LTD  and affiliates, 
and is intended for the sole use of the individual and entity to whom it is 
addressed. It may contain information, including any attachments, that is 
privileged, confidential and exempt from disclosure under applicable law. If 
you are not the intended addressee, nor authorized to receive for the intended 
addressee, you are hereby notified that you may not use, copy, disclose or 
distribute to anyone the message or any information contained in the message. 
If you have received this electronic transmission in error, please notify the 
sender immediately by a "reply to sender only" message and destroy all 
electronic and hard copies of the communication, including attachments.
This message was scanned for spam and viruses by BitDefender.

Other related posts: