[PCB_FORUM] 15.5 dangling vias setting?

Hi All,
We are having an issue where we have two boards in 15.5 and when doing a
dangling lines report one board also gives dangling vias the other does not.
Is there a check box or other parameter that we need to set in the board
file to allow this reporting? I have looked through all the user preferences
, etc. and do not see anything that looks helpful. I have also looked on
sourcelink and see that dangling vias is a new feature of 15.7 (but not
15.5?) so I am a little confused..... Any pointers in the right direction
would be appreciated.
Thanks in advance,
Dharma
 

KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents contain
information that is confidential, privileged or exempt from disclosure under
applicable law and is intended for the exclusive use of the addressee. This
information is private and protected by law. If you are not the intended
recipient, or have received this email in error, you are hereby notified
that any disclosure, copying, distribution or use of the contents of this
document in any manner is strictly prohibited.

Other related posts: