Keith is correct, I was up way too early, went to radio room and scanned around, XYl advised that I needed to get to house for breakfast and did not pay attention enough to see I was on.228,not .238...my apologies! Its back on correct freq!...73 Drew Sent via BlackBerry by AT&T -----Original Message----- From: "W. Keith Hibbert" <wkhibbert@xxxxxxxxxxx> Sender: 10mprop@xxxxxxxxxxxxxxxx Date: Fri, 15 Jul 2011 16:29:31 To: <10mprop@xxxxxxxxxxxxxxxx>; <hfbeacons@xxxxxxxxxxxxx> Reply-To: 10mprop@xxxxxxxxxxxxxxxx Subject: [10Mprop] BEACONS: Back At Work With The Mobile Hi, Keith here in Amherst, NY I had to go to a new construction site today, the task was 'Witness and Verify" which allowed me to observe the goings on from the cab of the truck. No excuse not to so I took the rig. First of, a new one for me, copied all morning and still coming in here: 28.2397 N4LEM - Cocoa, FL The signal started out on 28.2400 MHz and either my rig moved or the beacon moved, this afternoon I was copying it on 28.2397 MHz Next, I copied KB2SEO, but I copied it for 5 minutes on a different frequency: 28.2280 KB2SEO - Copied from 1402Z - 1407Z and then it dropped o ut. Two possibilities occur, the rig got bumped and Drew put it back or the rig went wandering and Drew shut it off. Either way, I did not copy anything on 28.228 or 28.238 for the rest of the day. I will have a complete list a bit later, I actually have to type up something for WORK first, long time since this has happened, hi! 73, Keith, WB2VUO Amherst, NY: Grid FN02ox -- You received this message because you are subscribed to the Google Groups "10Mprop" group. To post to this group, send email to 10mprop@xxxxxxxxxxxxxxxxx To unsubscribe from this group, send email to 10mprop+unsubscribe@xxxxxxxxxxxxxxxxx For more options, visit this group at http://groups.google.com/group/10mprop?hl=en.