I would use interlocking segments because they are the kind if cases
that are easiest for me to deal with.
On 02/24/2017 08:20 AM, Keith Elliott wrote:
That depends on what type of design you're going for. If you want a
single piece, folding case I'd say design in 2D. I haven't seen any
OpenSCAD features for "unfolding" a 3D design.
If you're designing it as interlocking segments, it'd be easy enough
to design each segment in 3D as a separate module() and when you go to
print it just use rotate() to align everything with the laser bed plane.
On Fri, Feb 24, 2017 at 5:54 AM, John Lewis <oflameo2@xxxxxxxxx
<mailto:oflameo2@xxxxxxxxx>> wrote:
I wanna to design some PC Duino cases in OpenSCAD for the Laser
cutter.
Should I design the whole piece in 3D and try flatten it to curves
afterwards?
