Sorry- you can also do exceptions by name or IP- here is an example: 10.*.*.* ; *.yaple.org ; *.sofcu.com This would route direct anything URL on the 10.0.0.0/8 network or any URL that matches the 2nd level domain names or yaple.org or sofcu.com Good luck, Omar _____ From: gptalk-bounce@xxxxxxxxxxxxx [mailto:gptalk-bounce@xxxxxxxxxxxxx] On Behalf Of Omar Droubi Sent: Monday, September 18, 2006 4:32 PM To: gptalk@xxxxxxxxxxxxx Subject: [gptalk] Re: Define as Local Network User Configuration-Windows Settings-Internet Explorer Maintenance- Connection- Proxy Settings. (define your subnets in the exceptions list) You should not have to use individual IP addresses- you can use wildcards 192.168.*.* or 192.*.10.* or something like that. Omar _____ From: gptalk-bounce@xxxxxxxxxxxxx [mailto:gptalk-bounce@xxxxxxxxxxxxx] On Behalf Of Justin Yaple Sent: Monday, September 18, 2006 4:00 PM To: gptalk@xxxxxxxxxxxxx Subject: [gptalk] Define as Local Network Hello, Is there any way to define a group of networks as being local through a GPO? I am implementing a proxy server to filter our web traffic through, but I don't want any local (traffic inside our network) going through them. The only way Iv been able to get around this is by using the exceptions list in the GPO, but I was hoping for a more inclusive method of doing this rather than by individual IP address. Thanks.