[gps-talkusers] Re: Hollux 1000 receiver question

Hi Albert, you don't connect the M-1000 using a USB cable. you use Blue Tooth 
which is wireless.  Go to your options menu and hit the letter C for
connect.  Then, hit letter B for blue tooth.   Now it will say starting
bluetooth.  After a few moments, the unit will ask you if you want to search
for devices.  Hit Y for yes.  After a few moments it will find the Holux
M-1000.  It may also find other devices like your cell phone or computer if
they have bluetooth.  Now you want to pair the Holux receiver  by doing
0000.  Next you will need to activate the receiver.  To do this, go to the
list of bluetooth devices and hit enter on the holux m-1000.  It may say
paired in which case you want to hit A for activate.  Or, it may say paired
and active.  Now go to your gps program and open it.  Hopefully it will find
the M-1000 receiver.
Now I want to make a disclaimer here.  I am only a user.  I use an Mpower BT
not a QT so there may be some differences in the letters you have to use in
order to find and activate your bluetooth receiver.  I am not familiar with
the QT. At any rate this is a start and I am sure you will get much clearer
advice from Kevin, Charles and probably numerous other folks on the list.  I
wouldn't have written but when I read your email, no one else had yet
answered your question.
So, forgive me for leaving out stuff or not splaining it clearly.  It's late
and I am going to sign off.  Good luck!  Jim
----- Original Message ----- From: "Albert Sanchez" <albertsanchez@xxxxxxxxxxxxxx> 
To: <gps-talkusers@xxxxxxxxxxxxx>
Sent: Thursday, December 27, 2007 11:29 PM
Subject: [gps-talkusers] Hollux 1000 receiver question



Hi List,
I want to connect my Hollux GPS receiver to my mPower BT32 and need to
know which USB connection to use, and, where do I find an adapter so that
I can connect the receiver to the USB cable.

Thx,
A.S.
Albert Sanchez
Al's Piano Tuning & Repair
215 John Avenue
Greenville, NC 27858-4113
252-757-3023

Other related posts: