[gps-talkusers] Re: Creating manual routes

Hey Sheila

It's Robert Antunez.  Do you have a skype name?  Drop me an email at 
robertantunez@xxxxxxxxxxx
  ----- Original Message ----- 
  From: Sheila Killian 
  To: gps-talkusers@xxxxxxxxxxxxx 
  Sent: Monday, May 21, 2007 11:20 AM
  Subject: [gps-talkusers] Re: Creating manual routes


  Hi,
  I am still trying to resolve this issue of creating manual routes. Here is 
what I have solved and where I am still stuck
  I have been trying to creat a manual route from my apartment to a rose garden 
a few blocks away. 
  1. I turned off automatic route recalculation, forced sequential waypoint 
following, auto increments off, look-around off, automatic announcements all 
turned off, in fact, everything I can disable I have done. 
  2. I go in to virtual mode, create a route and set my first waypoint at my 
starting point. 
  3. I then move along my route virtually, naming and describing waypoints as I 
go. I am very clear as to my cardinal directions.
  Now here is where the problems show up: The latter part of the route is not 
on the map because it is necessary to descend two  very long flights of stairs  
 to get to the rose garden. I have previously recorded some pois in gps mode 
while actually standing on the spot which are essential for completing the 
route.    I have added these as waypoints while in virtual mode at the proper 
locations including my destination.  
  However, While I travel along this route either virtually or physically I get 
the message warning! off route! If I try to recalculate it I get the error 
message unable to recalculate route or unknown route as well as the warning, 
off route message. Can someone give me any suggestions for how to resolve this 
problem? I want to solve this puzzle on a simple route before I attempt to go 
hiking and find that I am being given wrong compass directions to reach my 
destination.  
  Also, I just reversed the route virtually, and I could not get any heading at 
all. And, I have a related question. Is it possible to copy and paste a 
waypoint from one route into another route? I know I can do it within the same 
route, but when I tried to copy a waypoint, close one route and open a 
different one and paste,I got the message, nothing copied. I even tried keeping 
both routes open with the same result. This would seem to be especially helpful 
if one accidently erases a waypoint like I did and the very one needed resides 
in another route. 

  And finally I would Ideally like to create a route that begins and returns  
to my starting point without coming back by the same way. In other words, a big 
circle or rectangle. Reversing the route will not work in this situation. 
  Thanks for any help you can offer me.
  Sheila

  let all be harmonious, sympathetic, brotherly, kindhearted, and humble in 
spirit; not returning evil for evil or insult for insult, but giving
  a blessing instead; for you were called for the very purpose that you might 
inherit a blessing." (I Peter 3: 7-9)
  -----

Other related posts: