[foxboro] loading an alarm match specification file on startup of an alarm cad

here's my setup: dual headed system (unix v. 7.1.2, foxview)

here's what I want to do: have two alarm cads, one assigned to each
head (A and B) I want only priority 1, 2 and 3 alarms to go to the
alarm cad on head A, and only priority 4 alarms to go to head B

I think I know how to assign the cads to the separate heads by editing
the dmcfg.

and i may know how to filter alarms by priority by using a match file
(page 102-107 of B0193RV), but what i cannot figure out is how to make
the alarm cad load the match file when it starts up. the a fore
mentioned document speaks of calling the match file from a button, but
I don't want the operators to have to *do* anything for this to
happen.

is there a startup file I could run a display manager command in to do
that? thoughts?

-
Patron saints in general are broadband connections to the Almighty
- Michelle Delio, Wired News
 
 
_______________________________________________________________________
This mailing list is neither sponsored nor endorsed by Invensys Process
Systems (formerly The Foxboro Company). Use the info you obtain here at
your own risks. Read http://www.thecassandraproject.org/disclaimer.html
 
foxboro mailing list:             http://www.freelists.org/list/foxboro
to subscribe:         mailto:foxboro-request@xxxxxxxxxxxxx?subject=join
to unsubscribe:      mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave

Other related posts: