Re: [foxboro] foxboro Digest V4 #422

 
In a message dated 12/17/04 12:03:56 AM Mountain Standard Time,  
foxboro@xxxxxxxxxxxxx writes:
Here is  a procedure that uses the utility program "getpars" to determine the 
alarm  types that are set on your system for each of the  blocks.



I have used getpars extensively to report block parameters.  In one  case, I 
used it to generate "tuning reports" that gave the tuning parameters of  each 
control block by CP.  Done periodically, it gives a good history of a  
controller's evolution, and helps define when a particular controller's tuning  
was 
"messed with".  Getpars operates slightly differently from system to  system, 
but with a little trial and error, it's not too bad to use.  Good  luck!


 
 
_______________________________________________________________________
This mailing list is neither sponsored nor endorsed by Invensys Process
Systems (formerly The Foxboro Company). Use the info you obtain here at
your own risks. Read http://www.thecassandraproject.org/disclaimer.html
 
foxboro mailing list:             http://www.freelists.org/list/foxboro
to subscribe:         mailto:foxboro-request@xxxxxxxxxxxxx?subject=join
to unsubscribe:      mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave

Other related posts: