Is it true that these variables need to be set for all / most of the command line utilities. Cause when I use dedit to get a connectivity report I get messages that GMS_HOME not set, though I get the desired report. Regards Ajay Tathgir Reliance Industries Limited Mumbai - India "Johnson, Alex (Foxboro)" <ajohnson@xxxxxxxxxxx>@freelists.org on 22-06-2002 02:31:18 PM Please respond to foxboro@xxxxxxxxxxxxx Sent by: foxboro-bounce@xxxxxxxxxxxxx To: foxboro@xxxxxxxxxxxxx cc: Subject: Re: [foxboro] fdf_g, fdf_i A note on use the command line utilities. They need a couple of environment variables set. If you use the csh, try adding #For FoxView FoxDraw setenv GMS_HOME /opt/gms setenv WUHOME /opt/windu If you use the Bourne shell (sh), try adding: GMS_HOME=/opt/gms WUHOME=/opt/windu Regards, Alex Johnson Invensys 10707 Haddington Houston, TX 77063 713.722.2859 (office) 713.722.2700 (switchboard) 713.932.0222 (fax) ajohnson@xxxxxxxxxxx <mailto:ajohnson@xxxxxxxxxxx> Come to the Invensys Showcase: http://www.invensysshowcase.com/ <http://www.invensysshowcase.com/> _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: http://www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave