Re: [foxboro] Question - Installing Foxboro IADay 0 Ethernet / problem with Dell P4

I've observed successful I/A installs circa version 6.1 on several PC's
and laptops too.  I hope you have a written procedure (you can get these
from Foxboro Field service) as there are a number of very specific steps
that need to be followed starting with the partitioning of the hard
disk, partition sizes, NTFS file system, NT installation, service pack
installation, network setup etc....  I remember trying to get the list
of supported PC's but found that such a list is not really maintained
due to the number of PC's out there and the frequency of changes.  The
guys doing the testing seemed to have about a 90% success rate back when
they were testing a lot, maybe you are in the 10% part.   It could be
your NT4.0 ghost image is from a system where NT was not specifically
installed per I/A installation procedures.  In which case, you may want
to install NT from scratch. 

Rick Rys P.E.
www.R2Controls.com
508-369-5186 Cell
508-339-6633 Home Office
 



 
 
_______________________________________________________________________
This mailing list is neither sponsored nor endorsed by Invensys Process
Systems (formerly The Foxboro Company). Use the info you obtain here at
your own risks. Read http://www.thecassandraproject.org/disclaimer.html
 
foxboro mailing list:             http://www.freelists.org/list/foxboro
to subscribe:         mailto:foxboro-request@xxxxxxxxxxxxx?subject=join
to unsubscribe:      mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave

Other related posts: