Re: [foxboro] Fw: AW51E - Second Ethernet Card

Ajit,

While there may be a way to set this and make it stick, I've had to
embed these kind of commands in a script that runs at startup -
typically in /etc/fox under user_apps.dat

On 8/30/07, Ajit.S.Kumar@xxxxxxxxxxxxx <Ajit.S.Kumar@xxxxxxxxxxxxx> wrote:
> When I rebooted the AW51E box  the Second Ethernet  port stopped working
> ,I recorded this message in /var/adm/messages. Note the cable is connected
> to a CISCO 3550 series switch, where all
> the other PLANT wide Stations WP,AW,AP stations are connected.
>
> Aug 30 00:40:48 B2AW11 unix: SUNW,hme1: 100 Mbps full-duplex Link Up
> Aug 30 00:40:54 B2AW11 unix: SUNW,hme1:  hme_try_autoneg: parallel
> detection fault
> Aug 30 00:40:57 B2AW11 unix: SUNW,hme1: Using Internal Transceiver
> I  have seen one thing the ndd settings goes to default ie all to 1 , but
> when I change / force  the ndd settings as below it  working...Is there a
> way where I can force it to set as below or during startup or due I have
> to create a hme.config file in usr/kernel/drv.
>
> ndd -set /dev/hme adv_autoneg_cap 0
> ndd -set /dev/hme adv_100fdx_cap 0
> ndd -set /dev/hme adv_100hdx_cap 0
> ndd -set /dev/hme adv_10fdx_cap 1
> ndd -set /dev/hme adv_10hdx_cap 0
>
> Thx in adv.
> Regards
>
> Ajit
>
 
 
_______________________________________________________________________
This mailing list is neither sponsored nor endorsed by Invensys Process
Systems (formerly The Foxboro Company). Use the info you obtain here at
your own risks. Read http://www.thecassandraproject.org/disclaimer.html
 
foxboro mailing list:             http://www.freelists.org/list/foxboro
to subscribe:         mailto:foxboro-request@xxxxxxxxxxxxx?subject=join
to unsubscribe:      mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave

Other related posts: