Re: [foxboro] Display manager initial environment

Roger,

You need to edit the file /usr/fox/wp/data/fv_cmds.  Here you can define =
your own initial enviorment.

         ************************** EXTRACT START =
*****************************************

=3D=3D $DM_LOCAL N =3D CADUS "" #   terminal
                                #
disable monitor                 # don't set OM monitoring variables
mount $TMHST                    # mount the logical host
dmcmd ojinit                    #
#$SYSDIR/Change_Env/Init_Env    # call in initial environment
$OPTFOX/env/Initial.env         # call in initial environment
# $ENV1                         # call in configured first environment
# rev DGW 021199
$FV_ENV                         # call customised environment
=3D TCTOUT 10                   # set on-line trend cfg timeout to 2 sec
$INITDSP                        # call in initial display
        ***************************** EXTRACT FINISH =
****************************************

The variable FV_ENV is a user DM global defined in =
/usr/fox/wp/data/init.user

          ********************* EXTRACT START =
*****************************

# Define the user start up environment for use in fv_cmds
FV_ENV=3D/opt/fox/env/Proc_Op_Env.env

      ***************** EXTRACT FINISH  =
*************************************

Guess you could do this directly in the fv_cmds file just done this way =
for consistency.  Note that fv_cmds is over written by a Foxview =
upgrade. =20

Dave Williams
Snr Power and Control Engineer
Shell UK Oil Products Limited
Stanlow Manufacturing Complex, PO Box 3, Ellesmere Port, South Wirral =
CH65 4HB, United Kingdom

Tel: +44(0)151350 4480 Fax: 4566 Other Tel: +44 (0)7799 657836
Email: dave.g.williams@xxxxxxxxx
Internet: http://www.shell.co.uk


-----Original Message-----
From: Roger Smith [mailto:RSmith@xxxxxxxxxxxxxxxx]
Sent: 17 January 2003 21:32
To: Cassandra Project (E-mail)
Subject: [foxboro] Display manager initial environment



The documentation on display manager configuration indicates one can
configure the initial environment for a DM via the DM type parameter.
However, I can not get this to work.  I seem to remember this was a =
known
problem in the past, but I'm not sure.  Does this work now (I'm at =
V6.1.1),
and if so, are there some tricks to it?

Roger B. Smith
Chief, Process Control Engineering
Waste Water Services
City of Atlanta
404 350-4952

=20
=20
_______________________________________________________________________
This mailing list is neither sponsored nor endorsed by Invensys Process
Systems (formerly The Foxboro Company). Use the info you obtain here at
your own risks. Read http://www.thecassandraproject.org/disclaimer.html
=20
foxboro mailing list:             http://www.freelists.org/list/foxboro
to subscribe:         =
mailto:foxboro-request@xxxxxxxxxxxxx?subject=3Djoin
to unsubscribe:      =
mailto:foxboro-request@xxxxxxxxxxxxx?subject=3Dleave
=20
 
 
_______________________________________________________________________
This mailing list is neither sponsored nor endorsed by Invensys Process
Systems (formerly The Foxboro Company). Use the info you obtain here at
your own risks. Read http://www.thecassandraproject.org/disclaimer.html
 
foxboro mailing list:             http://www.freelists.org/list/foxboro
to subscribe:         mailto:foxboro-request@xxxxxxxxxxxxx?subject=join
to unsubscribe:      mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave

Other related posts: