Nope. The information shown on the CAD is not available through the OM and therefore is not available to DM/FV. Regards, Alex Johnson Invensys Process Systems Invensys Systems, Inc. 10707 Haddington Houston, TX 77043 713.722.2859 (voice) 713.722.2700 (switchboard) 713.932.0222 (fax) ajohnson@xxxxxxxxxxx -----Original Message----- From: foxboro-bounce@xxxxxxxxxxxxx [mailto:foxboro-bounce@xxxxxxxxxxxxx] On Behalf Of BrianLong Sent: Wednesday, December 29, 2004 10:03 AM To: Foxboro Subject: [foxboro] Disp manager Is there a way to convert a CAD drawing into a format for display manager? Thanks in advance, Brian AKD _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: http://www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: http://www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave