Re: [foxboro] Acrison Feeder into a INT30

David,

You should be able to do so.  I've only done this off-site to an older SLC's DF1
port, but as I recall the issues were:
1) cabling took some time to figure out
2) BUSOPT and PCADDR are not used - no data highway addresses needed
3) Make sure that in System Definition you don't use heartbeat - this heartbeat
is to monitor the link between the gateway and the KF2.  ECB15 HBEAT is a
different heartbeat - this is a DF1 diagnostic loopback command that the
PLC/device responds to - use it if your feeder supports it.

The Integrators for Allen Bradley manual briefly discusses direct-connect but
unfortunately does not discuss cabling.

Regards,

Kevin FitzGerrell
Carter Holt Harvey, Ltd.
+64 27 460 9994


Quoting David Johnson <drjohn@xxxxxxxxxx>:

> I am trying to interface an Acrison feeder to a new AB-INT30. Here's 
> how we were told to do this.
> 
> 
> INT30B---[serial]---KF2---[DH+]---KF2---[serial]---Acrison
> 
 
> if this is true, wouldn't it work to go
> 
> INT30B---[serial]---Acrison
> 
> Has anyone used an AB-Integrator without the KF2?
> 
> Any help would be appreciated.
> 
> Thanks,
> David
> 
>  
>  
> ______________________________________________________________________
> _
> This mailing list is neither sponsored nor endorsed by Invensys Process
> Systems (formerly The Foxboro Company). Use the info you obtain here at
> your own risks. Read http://www.thecassandraproject.org/disclaimer.html
>  
> foxboro mailing list: http://www.freelists.org/list/foxboro
> to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join
> to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave
>  
>  

 
 
_______________________________________________________________________
This mailing list is neither sponsored nor endorsed by Invensys Process
Systems (formerly The Foxboro Company). Use the info you obtain here at
your own risks. Read http://www.thecassandraproject.org/disclaimer.html
 
foxboro mailing list:             http://www.freelists.org/list/foxboro
to subscribe:         mailto:foxboro-request@xxxxxxxxxxxxx?subject=join
to unsubscribe:      mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave

Other related posts: