[foxboro] Sequence Block Goes to Manual

I have an IND sequence block that requests our AW (32AW01 in this case) to 
run a script called "control_stk".
:32AW01DMCMD := "dmcmd" script /usr/applic/control_stk";

If the AW is down, the sequence block goes to MANUAL.   Is there a good 
way to prevent this?  In my case, I would rather the sequence block ignore 
the fact that the AW is down, and continue to process like normal.  Can I 
force the IND block to stay in AUTO through an address on the MA 
parameter?

Ray Chouinard
Process Control
MeadWestvaco Corp
Escanaba, MI, USA

________________________________________________________________________
This email has been scanned for all viruses by the MessageLabs SkyScan
service._______________________________________________________________

This electronic message contains information from MeadWestvaco
Corporation or subsidiary companies, which may be confidential,
privileged or otherwise protected from disclosure.  The
information is intended to be used solely by the recipient(s)
named.  If you are not an intended recipient, be aware that
any review, disclosure, copying, distribution or use of this
transmission or its contents is prohibited.  If you have
received this transmission in error, please notify MeadWestvaco
immediately at postmaster@xxxxxxxxxxxxxxxxx
_______________________________________________________________________

 
 
_______________________________________________________________________
This mailing list is neither sponsored nor endorsed by Invensys Process
Systems (formerly The Foxboro Company). Use the info you obtain here at
your own risks. Read http://www.thecassandraproject.org/disclaimer.html
 
foxboro mailing list:             http://www.freelists.org/list/foxboro
to subscribe:         mailto:foxboro-request@xxxxxxxxxxxxx?subject=join
to unsubscribe:      mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave

Other related posts: