We are in the process of replacing a L&N DCS with a Foxboro I/A DCS.=20 -------------------------------------------------------------------------= ------- We are considering using the "GDEV" block for all our open/close valves=20 (single coil + dual coil solenoid & motor actuated) as well as all the=20 motor start/stop. (instead of using blocks: VLV, MOVLV, MTR) Who out there has standardized on the "GDEV" block for on/off open/close = control? What have you learnt by doing this? What are the advantages? What are = the disadvantages? -------------------------------------------------------------------------= ------ Another method our Foxboro Engineers have recommended to us is to use = the "CALC" block=20 (instead of GDEV, VLV, MOVLV, MTR) Has anyone gone this route? What have you learnt by doing this? What are the advantages? What are = the disadvantages? Thank You, Peter Bruley Plant Process Computer Analyst Xcel Energy - Sherco Generating Plant Peter.T.Bruley@xxxxxxxxxxxxxx _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave