FDSI folks, I am trying to create a Port, Generic Ethernet xml file for a new FBM232. No matter what I enter, when I try to save the configuration, I get an error message "Exception has been thrown by the target of an invocation". Even if I open up an existing one and try to save it with no changes I get the same error message. What am I missing? The configuration parameters are too simple to mess up, there are just 2; Select FBM Type (FBM232) and the IP Address. Duh! Any suggestions? Nothing in the manual offers any help. Joseph M. Riccardi 386-441-0250 Office 386-451-7607 Cell Joe@xxxxxxxxxxxxx "To give real service you must add something that cannot be bought or measured with money; and that is sincerity and integrity." - Donald A. Adams _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave