I believe that you are correct. -----Original Message----- From: Dolly Bareqet [mailto:dolly@xxxxxxxxxxxx] Sent: Tuesday, July 30, 2002 06:54 To: [ExchangeList] Subject: [exchangelist] RE: Setting up multiple domains http://www.MSExchange.org/ As far as I know SBS does not support multiple domains -----Original Message----- From: Bjorn Hellesylt [mailto:bjorn@xxxxxxxxx] Sent: Tuesday, July 30, 2002 8:23 AM To: [ExchangeList] Subject: [exchangelist] Setting up multiple domains http://www.MSExchange.org/ Hi, I posted this message before, but did not get any answers, so I am trying again. I am a totally newbe to E2K server and have just installed the 2000 SmallBusinessServer with E2K standard version. I am trying to set up several domains on one server. I have done the following: -Set up DNS with ex1.abc.com as a domain controller on server EX1 -Set up MX record ex1.abc.com to point to @xyz.com. Set up Mailbox store for EX1 -In Recipien Policy/Default Policy set up @xyz.com as smtp -In Default SMTP Virtual Server / Advanced Delivery / Fully-qualified Domain Name: ex1.abc.com (Tested and OK) -POP3 is set up with the correct IP address. -In Active Directory I have set up a user with bjorn@xxxxxxx as smtp e-mail address in both Exchange General and E-mail Addresses Then the big question is? What have I left out or what have I done wrong since this is not working? When sending to the address bjorn@xxxxxxx, I get the message in return saying that no such address exists. I have gone trough all the articles about setting up SMTP vitual servers on Microsoft site, but it obviousley does not cover all my problems. I will greatly appreciate any help in this matter. Regards Bjorn ------------------------------------------------------ You are currently subscribed to this MSExchange.org Discussion List as: dolly@xxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this MSExchange.org Discussion List as: discussions@xxxxxxxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')