Good day I have set up a routing group connector between two exchange servers in the same site. Mail is however not getting routed accross the connector. Below i have listed the error i am getting when sending mail accross this connection. What am i doing wrong?? Your message did not reach some or all of the intended recipients. Subject: Sent: 16/04/2003 15:45 The following recipient(s) could not be reached: Rory Grobler on 16/04/2003 15:45 A configuration error in the e-mail system caused the message to bounce between two servers or to be forwarded between two recipients. Contact your administrator. <sgitmx1.out.co.za #5.4.8> **Disclaimer** This communication is privileged and confidential and any unauthorized access is prohibited. The views or opinions expressed herein are solely those of the author and do not necessarily reflect the views and opinions of OUTsurance Insurance Company Limited or, its management. If you are not the intended recipient of this mail then please delete this communication and notify the sender accordingly.