Addtion to the previous post, Mail enable the Public folder if it is not yet mail enabled. -----Original Message----- From: Periyasamy, Raj [mailto:psraj@xxxxxxxxxxxx] Sent: Monday, February 18, 2002 10:26 AM To: [ExchangeList] Subject: [exchangelist] RE: Public Folders in 2000 http://www.MSExchange.org/ I understand the PUBLICFOLDERNAME@xxxxxxxxxxxxxxxxx is a standard Exchange mailbox. In this case, the easiest would be to set up a Inbox rule, so that all mails coming to this Inbox would get forwarded to the Public folder SMTP address. Before doing this, you need add the SMTP address of the public folder as a Contact in the PUBLICFOLDERNAME@xxxxxxxxxxxxxxxxx mailbox contacts folder. Regards, Raj -----Original Message----- From: Brandon Lockhart [mailto:blockhart@xxxxxxxxxxxxxxxxx] Sent: February 18, 2002 10:18 AM To: [ExchangeList] Subject: [exchangelist] Public Folders in 2000 http://www.MSExchange.org/ How can I create a rule that all e-mail going to PUBLICFOLDERNAME@xxxxxxxxxxxxxxxxx goes to a certain public folder? For example: FAXMACHINE1@xxxxxxxxxxxxxxxxx email ==> Public Folders\All Public Folders\FaxMachine1\ Thanks. ------------------------------------------------------ You are currently subscribed to this MSExchange.org Discussion List as: psraj@xxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this MSExchange.org Discussion List as: psraj@xxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')