Keep in mind that if you install SP3 over an RTM install, you have to manually run the ADC installation from the SP3 files to upgrade that utility - it doesn't happen automatically, at least it didn't in my case. Greg Lara ---------------------------------------------------------------------------- --------------------------- This e-mail message may contain privileged, confidential and/or proprietary information intended only for the person(s) named. If you are not the intended recipient, please destroy this message, and any attachments, and notify the sender by return e-mail. If you are not the intended recipient(s), or the employee or agent responsible for delivering the message to the intended recipient(s), you are hereby notified that any dissemination, disclosure or copying of this communication is strictly prohibited. ---------------------------------------------------------------------------- --------------------------- _____ From: Chris Wall [mailto:Chris.Wall@xxxxxxxxxxxxxxxxxxx] Sent: Monday, September 20, 2004 1:17 PM To: [ExchangeList] Subject: [exchangelist] RE: Exchange 5.5. to 03 install http://www.MSExchange.org/ I have the exact same issue going on here in my test environment. It has been recommended that I reinstall the latest exchange 2003 SP and then recreate the ADC connector and try again... Chris _____ From: Thomas Arena [mailto:arena@xxxxxxxxxxxxxxxxxxxx] Sent: Monday, September 20, 2004 12:52 PM To: [ExchangeList] Subject: [exchangelist] RE: Exchange 5.5. to 03 install http://www.MSExchange.org/ Interestingly enough the error message now does not have the "Warning-ADC Tools detected..." but only "Setup cannot continue because..." and then "please refer to your exchange 2003 documentation... Weird. I'll wait the night. Thanks again. -thomas