[duxuser] Re: embossing problem

Hi George,
 
If you mean hitting 2e yes, it still happens.

  _____  

From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On
Behalf Of George Bell
Sent: Sunday, May 30, 2010 5:02 PM
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] Re: embossing problem


Sorry, Gary.  I should have made it clear I'm referring to the Juliet's
panel.
 
George.

  _____  

From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On
Behalf Of George Bell
Sent: 30 May 2010 21:54
To: duxuser@xxxxxxxxxxxxx
Subject: [duxuser] Re: embossing problem



Hi Gary, 

Does this happen even after setting top of form via the control panel? 

George. 

_____________________________________________ 
From:   duxuser-bounce@xxxxxxxxxxxxx [ <mailto:duxuser-bounce@xxxxxxxxxxxxx>
mailto:duxuser-bounce@xxxxxxxxxxxxx]  On Behalf Of Gary Metzler 
Sent:   30 May 2010 18:52 
To:     duxuser@xxxxxxxxxxxxx 
Subject:        [duxuser] embossing problem 

Hi All, 

I am running dbt 10.5 with a Juliet pro 60 embosser.  Lately I have been
noticing that the documents have been starting embossing about a quarter of
the way down the page.  It is the same on both sides.  I use 8.5 x 11 inch
paper.  Is there some settings I need to check and change?  Any help would
be most appreciated.  Thanks,

Regards, Gary Metzler 
 <http://outtasighttravel.com/> http://outtasighttravel.com 
sendto:gmtravel@xxxxxxxxxxxxx 
messenger:gmetzler1150@xxxxxxxxxxx 
skype: garymetz

Other related posts: