Hi David, Is it possible you might have missed the following setting? George. -----Original Message----- From: duxhelp-bounce@xxxxxxxxxxxxx [ mailto:duxhelp-bounce@xxxxxxxxxxxxx] On Behalf Of David Spybey Sent: 04 January 2007 14:05 To: duxhelp@xxxxxxxxxxxxx Subject: [duxhelp] Re: embosser settings Following up on Christian's comments. I am finding that the embosser settings I make are not sticking and are lost each time I exit the software. I had not noticed the problem initially but I have just been in and out of DBT SR1 several times and the embosser set up is not remaining at all. On the same theme using 10.6 but not using the SR1 version. We have a staff machine which people log onto as different user names. I thought that when I loaded 10.6 onto the machine that the embosser settings I created would then be there for each user, even though they log on with different names. This does not seem to be the case. Any suggestions? David Spybey * * * * This message is via list duxhelp at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *