[duxhelp] Re: another graphics issue

  • From: "Peter Sullivan" <peter@xxxxxxxxxx>
  • To: <duxhelp@xxxxxxxxxxxxx>
  • Date: Tue, 16 May 2006 16:30:48 -0400

Lissa,

In a message after this one, you mentioned that the diagnostics page was
printed as graphics, because that mode was "left over" from embossing a
graphics image previously.

Perhaps the same thing is going on here.

Do you get a "squished" page number embossed when you emboss Bart after a
fresh power-up?

- Peter 

-----Original Message-----
From: duxhelp-bounce@xxxxxxxxxxxxx [mailto:duxhelp-bounce@xxxxxxxxxxxxx] On
Behalf Of Melissa Hirshson
Sent: Monday, May 08, 2006 3:09 PM
To: duxhelp@xxxxxxxxxxxxx
Subject: [duxhelp] another graphics issue

When I embossed the Bart graphic on my Express 150, it also embossed the
page number at the upper right hand corner in "high density" mode, which
means that it came out looking squished.

I will run your test shortly and report the results.

Lissa

* * *
* This message is via list duxhelp at freelists.org.
* To unsubscribe, send a blank message with
*   unsubscribe
* as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting http://www.freelists.org.  The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *


* * *
* This message is via list duxhelp at freelists.org.
* To unsubscribe, send a blank message with
*   unsubscribe
* as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting http://www.freelists.org.  The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *

Other related posts: