Warren, Do you mean that you had changed the embosser setttings within the embosser? - Peter -----Original Message----- From: duxhelp-bounce@xxxxxxxxxxxxx [mailto:duxhelp-bounce@xxxxxxxxxxxxx] On Behalf Of WarrenDFig@xxxxxxx Sent: Monday, March 14, 2005 8:21 AM To: duxhelp@xxxxxxxxxxxxx Subject: [duxhelp] Embosser setup woes I have a braille student who likes to receive her practice materials on single-sided 8-1/2 by 11 paper. I thought I'd create a separate embosser configuration so that my Juliet Pro 60 would take care of it. So after I made the configuration, I wanted to return to my original interpoint Juliet Pro 60 config. All my settings had been changed--the paper size was not correct and even when I returned it to the "Wide" setting I also had to put in the 40 as well--it wanted to retain the 34. The interpoint setting had been changed too. Then I returned to the new narrow config--its settings were also changed, too. What's up with that? Warren * * * * This message is via list duxhelp at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *