I agree with Joanie and Warren here - at least for this version. Anyone else going to chip in? George. -----Original Message----- From: duxhelp-bounce@xxxxxxxxxxxxx [mailto:duxhelp-bounce@xxxxxxxxxxxxx] On Behalf Of Peter Sullivan Sent: 17 March 2005 19:16 To: duxhelp@xxxxxxxxxxxxx Subject: [duxhelp] Embosser Setup: Question 3 Warren, Joanie, George, et al, If we handle the Global Embosser Setup dialog as it's now evolving, the OK button really becomes quite "loaded". It will: - Apply new default document settings for one or more embossers, - Update the embosser list to include any new embossers, remove any that were removed when operating the dialog, and update the definitions of any embossers that were edited, and - Select a default embosser (with all of its "sticky settings"). This is a lot for one OK button to do, especially considering that the first two things suggest that OK can apply changes that are not visible on screen. Should I be concerned about this? (I'll certainly be grateful for an answer of "No" -- it will save a lot of discussion.) - Peter * * * * This message is via list duxhelp at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * * This Message has been scanned for viruses by McAfee Groupshield. * * * * This message is via list duxhelp at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *