Hello All, I've just started using Sibelius and Sibelius Speaking earlier this week. I am very excited about this software and am grateful to everyone who worked towards getting this to work. I have a trouble shooting question. When I press control plus F5 in Sibelius, to load the staff layout into jaws memory, I get the following message: This function failed because a Sibelius Speaking plug in failed to create an initialization file. I've run all of the tests, including installing the Sibelius Speaking plug ins, and they were all successful. When I was setting everything up, I had Sibelius Speaking installed before I downloaded and installed the upgrade to Sibelius 3.1.1. Do I need to re-install Sibelius Speaking 3.1 after upgrading from Sibelius 3 to 3.1.1? Could this be the source of my problem? How important is it to get the control F5 opporation to work successfully? I've noticed that when I use the goto function, F5, while doing the tutorials it always drops me in the piano B staff instead of the piano A staff, even though everything I've entered is in the piano A staff. Is this related to the failure of the control F5 opporation? Can anyone direct me toward a solution? Thanks much, Bill Stevens ** To leave the list, click on the immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** ddots-l-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** ddots-l-request@xxxxxxxxxxxxx with the Subject:- faq