[ddots-l] Re: Moving a Coda Measure in Sibelius

Could you try moving the coda to the next line by moving to the measure
that contains the coda and pressing CTRL ENTER?  This would make the
measure with the coda move to the next line and start the staff. The
only problem with that is that you would have one measure that runs the
entire width of the page.  I would love to know the solution to that
part of the problem.  
Kevin

-----Original Message-----
From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx]
On Behalf Of Dave Carlson
Sent: Wednesday, November 24, 2004 12:47 PM
To: ddots List
Subject: [ddots-l] Moving a Coda Measure in Sibelius


I've got a single measure at the end of my score that is the Coda. When
printed this measure immediately follows the rest of the score with no
gap, so that the D.S. al Coda and the Coda mark actually overlap.

I want to move that single measure away from the rest of the score, for
example a 1/4 or 1/2 inch gap of white space.

I tried inserting a blank bar between them and then hiding it, but for
some reason the 5 staff lines still print. Close, but not what I want.

So how do I move that Coda measure away?

Dave


** To leave the list, click on the immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** ddots-l-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to 
** ddots-request@xxxxxxxxxxxxx with the Subject:- faq

** To leave the list, click on the immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** ddots-l-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click on the
** immediately-following link:-
** [mailto:ddots-l-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to 
** ddots-request@xxxxxxxxxxxxx with the Subject:- faq

Other related posts: