[softwarelist] Re: OvnPro 2.77 type 5 errors

In message <501817a297asgard@xxxxxxxxxxxxxx>
          Keith Hopper <asgard@xxxxxxxxxxxxxx> wrote:

>      After printing, there is a 56Mb dynamic area still allocated to
> AWRender Crystal supp - which I thought that OvnPro would have released.

No, this is under the control of the AWRender module.

> Perhaps that is awaiting normal OvnPro termination (which, of course,
> hasn't occurred because it crashed)?

It is awaiting termination of ArtWorks file rendering, so this might 
indicate that the crash occurred inside AWRender. As always, when an 
application calls a module, any crashes within the module code are 
handled by (and attributed to) the application.

Do you have the "where" command-line utility installed? If so, then 
typing *where in a TaskWindow after the crash gives information about 
the location of the crash.

Martin
-- 
---------------------------------------------------------------------
Martin Wuerthner           MW Software          lists@xxxxxxxxxxxxxxx
---------------------------------------------------------------------
To unsubscribe or subscribe goto: http://www.freelists.org/list/davidpilling

Other related posts: