The suggestions I have gotten are to defragment my hard drive, check it for
errors and do a disc cleanup.
I will try them, although I do not know why they would affect only K1000 and
not everything else. I try to keep my disc in good shape as far as cleaning
up goes, but I haven't defragged it in a long time. We'll see.
I'll keep you posted.
Hi, Evan. I can't help, unfortunately, but I do have K1000 and I can say
this is certainly not normal! Hopefully someone else will have some
suggestions because that would drive me crazy, too. Good luck. Take care.
--
Julie Morales
Email & Windows/MSN Messenger: mercy421@xxxxxxxxxxx
Skype: mercy0421 Please contact me if I may not recognize your contact info
before adding me or I may not add you!
Currently in Winchester Regional, Virginia Overcast, Rain 60F°(16C°)
Wind:NNE (020°) at 9mph (8KT) (direction variable)
"Montana --- At least our cows are sane!"
Created by WeatherSig v1.10 . http://www.weathersig.com
----- Original Message ----- From: "Evan Reese" <mentat1@xxxxxxxxxxxxxx>
To: <k1000@xxxxxxxxxxxxxxxxxxxxxxxx>
Sent: Friday, September 01, 2006 1:23 PM
Subject: [bksvol-discuss] K1000 Slowing Way Down
I installed the demo version of K1000 a little over two weeks ago. Now, the
program seems to do everything much more slowly than it did when I first
installed it.
When on repeated scan, I have it set to delay six seconds, but most of the
time now, I have to wait about twice that long for it to start scanning. It
used to say "scan complete" as soon as the scanner started going back up,
but now it takes several seconds. Just arrowing down from one page to the
next involves about five or more seconds of waiting to get a response. I
had to add a blank page this morning, and waited approximately ten seconds
to get a response. Search and replaces take a lot longer than they did when
I first installed this thing. Everything takes longer, and it is getting
quite maddening. I repeat: It was not like this when I first installed it.
To forestall the obvious questions:
I have not installed any other software since installing K1000.
I have not experienced any similar slowdown in any other program I use, such
as MSWord.
Closing K1000 and restarting it does not help.
Shutting down and restarting the computer does not help.
Is this a permanent feature of the program? It starts out zippy and turns
into a glacier? It would be irritating enough to have to wait more than
five seconds to go from one page, for example, to the one immediately below
it. But it is much worse knowing that it wasn't that way in the beginning.
Does anyone have a solution to this problem? This is starting to drive me up a wall.
Thanks for any help.
To unsubscribe from this list send a blank Email to
bksvol-discuss-request@xxxxxxxxxxxxx
put the word 'unsubscribe' by itself in the subject line. To get a list of available commands, put the word 'help' by itself in the subject line.
To unsubscribe from this list send a blank Email to bksvol-discuss-request@xxxxxxxxxxxxx put the word 'unsubscribe' by itself in the subject line. To get a list of available commands, put the word 'help' by itself in the subject line.
