In message <a65ffcb74f.tim@xxxxxxxxxxxxxxxxxxxxx> Tim Powys-Lybbe <tim@xxxxxxxxx> wrote: > In message of 1 Jul, Martin Wuerthner <lists@xxxxxxxxxxxxxxx> wrote: >> In message <619bf9b74f.tim@xxxxxxxxxxxxxxxxxxxxx> >> Tim Powys-Lybbe <tim@xxxxxxxxx> wrote: >>> I cannot see any way of getting the Nudge Size below 0.1 cm. Is there >>> one? >> >> I must be missing something. What happens when you simply set the >> nudge size to 0.1mm? [iconbar "Choices...", then "ArtWorks"] > Thanks! It's easy when you know how. All the other units on that page > had separately chooseable dimensions which I had been kicking all over, > never realising that this was a text-defined unit. Just for clarification: The controls you are referring to are just there to choose units as such, nothing else. They allow you to set the default units used for displaying values and for entering values if you do not enter any unit. The nudge size field is for setting a *size* so it is something entirely different. All the fields that set a size in ArtWorks take measurements in any of the supported units. Martin -- --------------------------------------------------------------------- Martin Wuerthner MW Software lists@xxxxxxxxxxxxxxx --------------------------------------------------------------------- ------------------------------------------------------------ To change, suspend or cancel your subscription go to //www.freelists.org/list/artworks ------------------------------------------------------------