[argyllcms] Re: monitor calibration using Colormunki

  • From: adam k <aak1946@xxxxxxxxx>
  • To: "argyllcms@xxxxxxxxxxxxx" <argyllcms@xxxxxxxxxxxxx>
  • Date: Wed, 13 Oct 2010 18:11:07 -0400

I meant to measure ambient light next to my monitor.

Sent from iPhone

On Oct 13, 2010, at 5:55 PM, Graeme Gill <graeme@xxxxxxxxxxxxx> wrote:

> adam k wrote:
>> Simple question (I hope)
>> Is it better to calibrate monitor with ambient light measurement or without?
>> I have Dell U2410 monitor and my goal is to match my prints as close as
>> possible.
>
> If you are aiming to do side by side proofing, then your viewing
> conditions should be identical between print and screen, so no,
> there shouldn't be any ambient light differences between source
> and destination to compensate for.
>
> Graeme Gill.
>
>
>

Other related posts: